How the innovation works?
Even 90% of CH installation is not balanced properly! How to change it?
Only by using THB23030 by steady temperature measurement (at the start and end of the loop), actuators maintain optimal difference of temperature (ΔT) and adjust automatically the water flow.
Hydraulic calobration reduces annual energy consumption by 10–20 kWh/m2. It gives over 200€ of savings for a 100m2 house.
What may make the hydraulic calibration difficult?
Lack of plans or precised calculation of system capacity demand
No matter if the investment is just beginning to develop or it’s already in use. Still proper flow measurmet is being made very rarely.
Various length and concentration of the heating loop
They have direct impact on the flow meters set. All has to be measured and adjusted oftenly, if we want to get equal temperature in the whole heating zone.
The quality and completion of the underfloor heating system
The proper installation of each layer is very important for proper system functioning but not for each we do have an impact.
The type of used floor
Tiles in the kitchen area and panels in open-space living zone? It really affects on efficiency of your UFH system. Depending on used materials, heating distribution and pereciving of it will be different.
Arrangement of heated rooms or a make-over
Placing of the furniture, especially the big-sized one, may disturb the heat emission.
Low quality or constantly exploating flow meters
The exploatation is inevitable. In such case, the original settings of the flow meters may accure as inneficient.
Sudden weather change
If weather breakdown comes once the calibration is finished, it may be impossible for the system to ensure the accurate temperature in the room. The flometers have to be set again.
Find out what you can get by choosing an innovative regulation!
Technical specification
| Supply | 230V AC 50 Hz |
| Rating Max | 0,5 W |
| Accuracy of temperature measurement | 0,1ºC |
| Type | NC = Normally closed |
| Closing and opening times | 30 seconds |
| Thread’s size | M30 x 1,5 |
| Dimension [mm] | 93 x 38 x 54 |
Contact a specialist!
Phone: +48 570 199 777
or serwis@salus-controls.pl
Monday – Friday: 8.00 – 16:00
We reply to an email within 24 hours.
(workdays mon-fri)
